Coatings work can fail before the first brush touches a part if the surface has not been prepared properly. Propspeed has launched its Like A Pro toolkit to help marine applicators follow a consistent process when using the company's systems.
The release relates to technique and installer support, rather than a promise that every boat will see the same performance outcome. Smaller craft can benefit from professional preparation as much as larger vessels.
Preparation comes first
Metal and other underwater surfaces require the correct cleaning and treatment before a coating is applied. The manufacturer's process sets out product sequencing and the practical details that support adhesion.
An unsuitable solvent or contaminated surface can compromise the job. Applicators must work to current safety and material instructions.
Different parts, different products
A propeller, shaft or specialist underwater surface may need its own compatible coating treatment. The correct system depends on material and the maker's approved use.
Owners should not substitute a product because two packages have similar names. The service yard should document what was applied and when.
The value of a recorded job
Maintenance records make it easier to understand wear and plan the next haul-out. A toolkit can help standardise work, but it does not replace inspection after a season in the water.
LBG reports Propspeed's official release and image with attention to ordinary leisure-boat maintenance. No fuel-saving number is implied without relevant test conditions.